Emissions Control System / OBD2 Readiness Monitors
Stored / history data trouble code(s) are present in vehicle ECM.
(Check engine light is not currently on,Advise clearing code(s) and driving to see if comes back,This does not necessarily mean there is an issue,P0087 fuel rail system pressure too low.)
HVAC / Cooling
Inspection Point
Result
Inspector Comments
Heater / Air Conditioning / Blower Fan
A/C service port cap is missing.
(Both)
Powertrain
Inspection Point
Result
Inspector Comments
Universal Joints Axle / Driveshaft
The driveshaft is leak a small amount of Grease towards the carrier bearing area.
Battery passed the health test and terminals are free from corrosion
Brake fluid water content tests acceptable
Coolant temperature protection level tests acceptable
The driver-side front seat belt door trim is not properly secured.
The front windows have excessive tint.
Timing belt
This vehicle is equipped with an engine timing belt. Although it is not inspected as part if the inspection, the manufacturer recommends replacement every 105,000 miles.
Comments
Inspection Comments
All safety components of this vehicle were marked "acceptable" at the time of inspection.
At the time of inspection, all on-board diagnostic (OBD) readiness monitors were ready, the check engine light was operational with key on but not illuminated with engine running, and emissions components were marked "acceptable."
Seller Comments
This vehicle has new cabin and engine air filters. We also changed the oil.
All safety components of this vehicle were marked "acceptable" at the time of inspection.
At the time of inspection, all on-board diagnostic (OBD) readiness monitors were ready, the check engine light was operational with key on but not illuminated with engine running, and emissions components were marked "acceptable."